Danley DNA SC48, Руководство пользователя

Страница: 22 / 44

22
Storing Module Presets
Once a drive module has been created it can be stored by pressing the < INPUT > button until the
edited channel is reached, then pressing the down <

> button until store page is reached. Using
encoder “
A
” will change the preset number
. When the destination preset is reached, pressing the
<
ENTER
> button will enable the name associated with that preset to be changed. Once the name
changing i
s active, the character to be changed will be highlighted and encoder “
C
” will
edit the
character. Using encoder “
B
” will move
through the character positions. Once the new preset name
has been assembled, the operation can be confirmed by pressing the < ENTER > button, then a
message will be displayed, “Enter to confirm or

to exit”
; pressing < ENTER > will store the preset.
Note: Storing a Drive Module preset for a module which is not configured with consecutive
outputs is not permitted.
Note: When storing a Drive Module preset on the device, Component Names cannot be edited. To
change Component names, the Module Preset must be saved in the System Engineer application.
Recalling Module Presets
To recall a Drive Module preset, press the < INPUT > button, then use the down <

> button navigate
to the RECL Preset page. Using the encoder,
“
A
” will scroll through the presets available. When the
desired preset is reached, pressing <
ENTER
> will display the message
“
Enter to confirm or

to
exit”
, pressing <
ENTER
> will recall the preset. Note that presets do not contain and do not disturb
parameter Overlays. See Overlays
Recalling Components
To recall a Component Preset (to a single output), press the < OUTPUT > button, then use the down
<

> button navigate to the RECL Preset page
. Using the encoder, “
A
” will scroll through the
component presets available (as indicated by the ModulePreset.Component number and
ModulePreset.Component name). When the desired component is reached, pressing < ENTER > will
flash the Enter button. Pressing < ENTER > again will then recall the component preset. Note that
component presets do not contain and do not disturb parameter Overlays. See Overlays