3. Hold the outer part of the assembly tool in the bottom of the steering unit housing and guide the
inner part of the tool right to the bottom.
Guid the inner part of the tool to the bottom
4. Press and turn the shaft seal (5) into position in the housing.
5. Draw the inner and outer parts of the assembly tool out of the steering unit bore, leaving the guide
from the inner part of the bore
6. Guide the spool and sleeve into the bore with a light turning movement.
Fit the spool set holding the cross pin (11) horizontally.
VSPP with spool set
Service Manual
VSPP Steering unit
VSPP assembly
24 |
©
Danfoss | November 2019
AX319758618681en-000101
