Danfoss VLT OneGearDrive, Руководство по эксплуатации

Страница: 6 / 36

1 Introduction
1.1 Symbols used in this Manual
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operating equipment
at less than optimal performance.
1.2 Approvals
Table 1.1 Approvals
1.3 Copyright
Disclosure, duplication and sale of this document, as well
as communication of its content, are prohibited unless
explicitly permitted. Infringement of this prohibition incurs
liability for damages. All rights reserved with regard to
patents, utility patents, and registered designs.
OneGearDrive is a registered trademark.
1.4 Disclaimer
No liability is assumed for any damage or breakdown
resulting from:
•
Failure to observe the information in the
instruction manuals
•
Unauthorised modifications to the VLT
®
OneGearDrive
•
Operator error
•
Improper work on or with the VLT
®
OneGearDrive.
1.5 Service and Support
Contact your local service representative for service and
support:
www.danfoss.com/Contact/Worldwide/
1.6 Purpose of these Operating Instructions
The purpose of these Operating Instructions is to describe
the VLT
®
OneGearDrive. These Operating Instructions
contain information about:
•
Safety
•
Installation
•
Commissioning
•
Maintenance and Repair
•
Specifications
•
Options and Accessories
NOTE
For reasons of clarity, the Operating Instructions and safety
information do not contain all information relating to all
geared motors types and cannot take into account every
conceivable case of installation, operation, or maintenance.
The information is limited to that which is required for
qualified personnel in normal working situations. Any
unclear points can be clarified by contacting Danfoss.
These Operating Instructions are intended for use by
qualified personnel. Read these Operating Instructions in
full in order to use the VLT
®
OneGearDrive safely and
professionally. Pay particular attention to the safety
instructions and general warnings.
Introduction
VLT
®
OneGearDrive Operating Instructions
4 MG75C302 - VLT
®
is a registered Danfoss trademark
1 1