Danfoss VLT OneGearDrive, Руководство по эксплуатации

Страница: 17 / 36

3 Commissioning
3.1 Measures before Commissioning
3.1.1 Overview
If the VLT
®
OneGearDrive has been stored, the measures
detailed in 3.1.2 Motor Component and 3.1.3 Gear Unit
Component must be taken.
3.1.2 Motor Component
•
Insulation measurement
Measure the insulation resistance of the winding
with commercially available measuring apparatus
(e.g. with a megger) between all winding parts
and between the winding and the enclosure.
Measured value Action/State
> 50 megohm No drying necessary, new condition
< 5 megohm Drying advised
approx 50 megohm Lowest permissible threshold
Table 3.1 Insulation Measurement Values
3.1.3 Gear Unit Component
•
Lubricant
The lubricant in the gear unit must be changed if
the storage period exceeds 3 years or the
temperatures were very harsh throughout a
shorter storage period. For detailed instructions
and lubricant recommendations see
4.4.3 Lubricant Volume .
•
Shaft seals
Lubricate the hollow shaft seal with grease if the
storage period exceeds 2 years. When changing
the lubricant, the function of the shaft seals
between the motor and gear unit as well as on
the output shaft must also be checked. The shaft
seals must be replaced if any change in shape,
colour, hardness or sealing effect is detected.
3.2 Commissioning
•
Remove the protective films.
•
Disconnect the mechanical connection to the
driven machine as far as possible and examine
the direction of rotation in the no-load state.
•
Remove feather keys or secure them in such a
way that they cannot be ejected.
•
Ensure that the current draw in the loaded
condition does not exceed the rated current
indicated on the nameplate for any length of
time.
•
Observe the drive unit after first commissioning
for at least one hour for any unusual heat or
noise.
Commissioning
VLT
®
OneGearDrive Operating Instructions
MG75C302 - VLT
®
is a registered Danfoss trademark 15
3 3