Danfoss VLT FCM 305, Руководство пользователя

Страница: 62 / 106

VLT
®
FCM Series
Used together with
Process, closed loop
mode
(parameter 100).
Description of choice:
Is only active when parameter 203 has been
set to
Min-Max
[0].
415 Maximum feedback
(MAX. FEEDBACK)
Value:
(par. 414) FB
LOW
- 100,000,000
[- 100000000]
✭
1.500.000 [1500000]
Function:
See description of parameter 414.
416 Reference/feedback unit
(REF/FEEDB. UNIT)
Value:
NO UNIT [0]
✭
% [1]
PPM
[2]
RPM [3]
bar [4]
CYCLE/min [5]
PULSE/s [6]
UNITS/s
[7]
UNITS/min [8]
UNITS/h [9]
°C [10]
Pa [11]
l/s
[12]
m
3
/s [13]
l/min [14]
m
3
/min [15]
l/h [16]
m
3
/h
[17]
kg/s [18]
kg/min [19]
kg/h [20]
t/min [21]
t/h
[22]
m [23]
Nm [24]
m/s [25]
m/min [26]
°F
[27]
in wg [28]
gal/s [29]
ft
3
/s [30]
gal/min [31]
ft
3
/min
[32]
gal/h
[33]
ft
3
/h [34]
lb/s [35]
lb/min [36]
lb/h
[37]
lb ft
[38]
ft/s [39]
ft/min [40]
Function:
Choose among different units to be shown
on the display.
This unit is also used directly in
Process regulation,
closed loop
as a unit for
Minimum/Maximum reference
(parameters 204/205) and
Minimum/ Maximum
feedback
(parameters 414/415).
The possibility of choosing a unit in parameter
416 will depend on the choices made in the
following parameters:
Par. 002
Local/remote control.
Par. 013
Local control/config. as par. 100.
Par. 100
Configuration
.
Select parameter 002 as Remote control
If parameter 100 is selected as
Speed regulation,
open loop
, the unit selected in parameter 416
can be used in displays (par. 009-12
Feedback
[unit]
) of process parameters.
Note: The reference can only be shown in Hz
(Speed regulation, open loop
).
If parameter 100 is selected as
Process regulation,
closed loop
, the unit selected in parameter 416
will be used when displaying both reference
(par. 009- 12:
Reference [unit]
) and feedback
(par. 009-12:
Feedback [unit]
).
Select parameter 002 as Local control
If parameter 013 is chosen as
LCP control and
open loop
or
LCP digital control and open loop
,
the reference will be given in Hz, regardless of the
choice made in parameter 416. If parameter 013 is
chosen as
LCP control/as par
. 100 or
LCP digital
control/as par. 100
, the unit will be as described
above under parameter 002,
Remote-control
.
NB!:
The above applies to display of
Reference
[unit]
and
Feedback [unit]
. If
Reference [%]
or
Feedback [%]
is selected, the value displayed
will be in the form of a percentage of the selected range.
✭
= factory setting. () = display text [] = value for use in communication via serial communication port
MG.03.H3.02 - VLT is a registered Danfoss trademark
62