Danfoss VLT FC 103, Инструкция по эксплуатации

Страница: 23 / 94

1
190
[7.5]
75
[3.0]
126
[4.9]
95
[3.7]
2
130BC534.10
Figure 2.12 Load share and Regeneration Terminals, D4h
1 Front view
2 Side view
Table 2.5
2.4.4 Motor Cable
The motor must be connected to terminals U/T1/96, V/
T2/97, W/T3/98. Ground to terminal 99. All types of three-
phase asynchronous standard motors can be used with an
adjustable frequency drive unit. The factory setting is for
clockwise rotation with the adjustable frequency drive
output connected as follows:
Terminal no. Function
96, 97, 98, 99 Line power U/T1, V/T2, W/T3
Ground
Table 2.6
2.4.5 Motor Rotation Check
The direction of rotation can be changed by switching two
phases in the motor cable or by changing the setting of
4-10 Motor Speed Direction .
•
Terminal U/T1/96 connected
to U-phase
•
Terminal V/T2/97 connected
to V-phase
•
Terminal W/T3/98
connected to W-phase
96 97
U V
96 97 98
U V W
98
W 130HA036.10
Table 2.7
A motor rotation check can be performed using 1-28 Motor
Rotation Check and following the steps shown in the
display.
Installation
VLT
®
Refrigeration Drive Instruction Manual
MG16J122 - VLT
®
is a registered Danfoss trademark 2-11
2 2