Danfoss VLT Center Winder MCO 352, Руководство по эксплуатации

Страница: 33 / 38

6 Troubleshooting
Parameter 19-93 indicates the error status of the Center Winder Controller. Several different conditions can be detected.
NO ALARM [0]
TENSION LIMIT DETECTED [1]
FC ALARM [2]
MCO305 ERROR [3]
QSTOP [4]
LOCAL MODE [5]
Table 6.1: Center winder error, par. 19-93
Turning the tension off resets all fault conditions while in remote mode.
All messages are shown in the LCP display of the FC 300 in short and in the APOSS software in plain text.
You can find brief information on the error messages in the table or detailed information in the following section.
The tables contain the messages in numerical order. Letters following a % sign represent variables which can be used in plain text at the corresponding
locations
Error no Error Text Description
103 Illegal axis num. Axes not in system
105 Error not reset Error not cleared
106 Home not done Failed to move to HOME position
107 Home vel. zero Home was executed with Home Velocity set to zero
108 Position error Position error
109 Index not found Index pulse (encoder) not found
110 Unknown cmm. Unknow command
111 SW end limit Software end limit activated
112 Unknown param. Illegal parameter number
113 FC not enabled FC 300 is not ready but the PID controller is active
114 Too many loops Too many nested loops
115 Par. save failed Parameter save failed
116 Param. memory Parameters in memory are corrupted
117 Progr. memory Programs in memory are corrupted
118 Reset by CPU Reset by CPU
119 User abort User abort
125 HW end limit HQ end limit activated
149 Too many inter. Too many interrupt functions
150 No ext. 24V External supply is missing
151 Too many gosub Too many nested GOSUB commands
152 Too many return Too many RETURN commands
154 D. out overload Digital Output overloaded
155 LINK failed LINKGPAR command failed
162 Memory error Error in veryfying; EEPROM: address % defect
170 Array size (DIM) Error in DIM command
171 Array too small Attempt was made to cross array bounds
179 Waitndx timeout Timeout while waiting for index
184 Too many ontime Too many time interrupts
187 Out of memory No more room for variables
190 Memory locked The program memory is write-protected
191 Illegal cam array Curve array wrong
192 Encoder error Encoder error
199 Internal MCO fault Internal MCO fault
VLT
®
Center Winder MCO 352 6 Troubleshooting
MG.33.T1.02 - VLT ® is a registered Danfoss trademark
33
6