Danfoss VACON OPTE3, Руководство по установке

Страница: 10 / 64

5.
6.
7.
- a.
- b.
-
c.
-
-
Install the option board into the slot E or D on the control board of the AC drive. Make sure that the grounding plate fits
tightly in the clamp.
e3
0b
i0
38
.1
0
In IP21, cut free the opening on the cover of the AC drive for the fieldbus cable.
Install the cables. When installing option boards with D9 connector, use a separate grounding cable for grounding.
To make a 360° grounding, strip the cables connected to the D9 connector and install the grounding cable con-
nector around the stripped part of the cables.
Attach the cable shoe to the short grounding bracket at the other end of the grounding cable with a screw.
When the D9 connector is mounted to option board, install the grounding cable to the grounding cable connector
mounted around the stripped cable in step a.
With D9 connectors on both slots D and E:
For slot D, mount first the option board and route the grounding cable below all cables. Make sure that the
cable connector is facing down.
For slot E, route the option board grounding cable on top of the cables.
AN338644703080en-0002 / DPD02156 10 | Danfoss A/S © 2022.08
Installing
VACON® RS485 and CAN Bus Option Boards
Installation Guide