Danfoss VACON OPTE3, Руководство по установке

Страница: 59 / 64

•
LED status Description
Single blink At least one of the error counters of the CAN controller has reached or exceeded the warning level (too many
error frames).
Double blink A guard event (NMT slave or NMT master) or a heartbeat event (heartbeat consumer) has occurred.
Quadruple blink An expected PDO was not received before the event timer elapsed.
ON The CAN controller is bus-off.
Table 28: M = CANopen run, Green
LED status Description
Blinking The CANopen device is in the pre-operational state.
Single blink The CANopen device is in the stopped state.
ON The CANopen device is in the operational state.
7.5 LED Indications on OPTC6 Option Board
NOTE! LED N is unused.
2
1
3
4
5
A
M
X6
X1
e3
0b
i1
79
.1
0
Illustration 50: LED Indications on VACON
®
OPTC6 Option Board
A CANopen board status, Green
M Fieldbus status, Green
Table 29: A = Board Status, Green
LED status Description
OFF Option board not activated
ON Option board in initialization state waiting for activation command from the AC drive
Blinking fast (once per s) Option board is activated and in RUN state
Option board is ready for external communication
Table 30: M = Fieldbus status, Green
LED status Description
OFF
Fieldbus module is waiting for parameters from the AC drive.
No external communication
ON
Fieldbus module is activated.
Parameters received and module activated.
AN338644703080en-0002 / DPD02156 | 59 Danfoss A/S © 2022.08
Troubleshooting
VACON® RS485 and CAN Bus Option Boards
Installation Guide