Danfoss VACON NXS Air-cooled, Руководство по эксплуатации

Страница: 174 / 196

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Troubleshooting
This fault cannot be reset from the control panel.
Switch off the power.
DO NOT RESTART THE DRIVE or CONNECT THE POWER!
Ask instructions from the factory. If this fault shows at the same time with Fault 1, do a check of the motor cable and the motor.
12.10.11 Fault 8 - System fault, Subcode S1 - ASIC phase feedback
Cause
operation malfunction
defective component
Troubleshooting
Reset the fault and start the drive again.
If the fault shows again, ask instructions from the local distributor.
12.10.12 Fault 8 - System fault, Subcode S4 - ASIC trip
Cause
operation malfunction
defective component
Troubleshooting
Reset the fault and start the drive again.
If the fault shows again, ask instructions from the local distributor.
12.10.13 Fault 8 - System fault, Subcode S5 - Disturbance in VaconBus
Cause
operation malfunction
defective component
Troubleshooting
Reset the fault and start the drive again.
If the fault shows again, ask instructions from the local distributor.
12.10.14 Fault 8 - System fault, Subcode S6 - Feedback of charging switch
Cause
operation malfunction
defective component
Troubleshooting
Reset the fault and start the drive again.
If the fault shows again, ask instructions from the local distributor.
12.10.15 Fault 8 - System fault, Subcode S7 - Charging switch
Cause
operation malfunction
defective component
Troubleshooting
Reset the fault and start the drive again.
If the fault shows again, ask instructions from the local distributor.
AQ275638903263en-000601 / DPD00910 174 | Danfoss A/S © 2022.12
Specifications
VACON® NXS/NXP Air-cooled
Operating Guide