Danfoss SonoMeter 30, Руководство пользователя

Страница: 4 / 4

© Danfoss | DHS-SRMT/SI | 2019.10 4 | VU.SH.I1.02
User guide Ultrasonic heat meter SonoMeter 30
Measurement units, flow pipe tagging,
calibration can be configured in “ Manufacturer ”
window.
Select energy units option in “ energy unit ” field
3.5 Volume calibration and press “ set ” in order to configure what energy
units are used for measurements. If device is
successfully configured message “ Operation
done ” will pop up.
If device is going to be placed on flow pipe, tag
“ Flow pipe ”. If device is going to be placed on
return pipe, tag “ Return pipe ”. Press “ set ” to save
configuration into device. If device is successfully
3.5.1 Changing pipe type
configured message “ Operation done ” will pop
up. If is it needed that device measure only
heating energy, “ heating only ” box should be
tagged.
Press “ Read ” and then press “ Manufacturer Reset ”.
Disconnect the battery from the device. Use a
jumper to short the contacts on the device for
3.5.2 Resetting device 3 seconds in place where need to be connect
the battery. Connect a battery to the device and
reconfigure the date and time parameters.
Place jumper under removed device cover
(see Fig. 4). Press “ Read ” and then write error
“ Err % ” and flow “ Q ” data. Press “ set ” to save
3.5.3 Calibration configuration into device. If device is successfully
configured message “ Operation done ” will pop
up.
Table 1
“Manufacturer” window parameters
No. Name Note
1 Calculator
-
2
Flow pipe (T1)
3 Return pipe (T2)
4 Heating only Check this when device is only for heating energy measurements
5
Calibration -
6 set Press button to save configuration to device device
7 Calibration parameters Write calibration parameters here
8 Energy unit -
9 set Press set to save energy unit parameter configuration
10
Manufacturer Reset Press to reset the device
Fig. 4
Jumper Position “TEST”