Danfoss Optyma OP-UPAC015COP04E, Инструкции по применению

Страница: 23 / 48

4. Installation
• Install the unit on the leeward of building, or under the eaves.
• When installing the unit at coastal area, protect it from briny air with a windshield plate, or the like.
• Provide measures to wash off salt particles adhered to external panels of the unit. Take care not to cover the unit with a sun shield, etc.
• Standing water over the bottom plate of outdoor unit accelerates corrosion badly. Tilt the plate, or take other means to drain water
effectively.
• Secure a better draining capacity at the foundation.
• When installing the unit at coastal area, wash off with water adhered salt or fouling at regular intervals from the surface.
Caution for maintenance:
When the unit is not operated for a long time after the season, or other, protect it unit with a cover, etc.
4.2 Caution for installation work
4.3 Delivery and installation of the condensing unit
Anchor bolt position
• Make sure to fix the fixing legs of refrigerating machine with 4 pieces of anchor bolt (M10). Optimum height of bolt above the surface
is 20 mm.
Foundation
• Confirm that the strength and levelness of foundation can prevent vibration and noise.
• The foundation must be larger than the shadowed areas in the above figures (larger than the front of the fixing legs of condensing unit).
• The foundation must run in the lateral direction of condensing unit as shown above (in the direction of the width of 1,350 mm).
• Fix the unit securely so that it will not be toppled by earthquake, or sudden gust.
Rubber cushion
• Size of rubber cushion must be able to support the entire bottom area of fixing leg. (See following figure.)
X
Y
Z
NOTE:
a) Install the cushion rubber such that it will support the entire bottom area of the fixing leg of condensing unit.
b) It is prohibited that the bottom area of the fixing leg runs out the cushion rubber partially, or it is supported partially only by the cushion
rubber.
Fig. 10
Fig. 11
X
Y
Z
(Main body dimension)
Unit
(M
ain body dimension)
(Anchor bolt dimension)
Anchor bolt dimension
Foundation
100 mm
or mor
e
Normally, provide the
foundation as shown above
It cannot be used in the
direction of existing
foundation
In case of renewal, add a
foundation at the center to
prevent deflection
Anchor bolt position (
•
mark)
Refrigerating machine
Rubber
cushion
23
AB408540130380en-000102 © Danfoss | Climate Solutions | 2023.02
Application Guidelines