Danfoss MPE 70, Руководство по эксплуатации

Страница: 7 / 64

Operating guide |MPE 70
7
180R9426 | AQ367027814446en-000801 | IOM MPE 70 | 08.2022
3. Safety 3.1 General
The MPE 70 must not be used for other
purposes than those recommended and
specified without first consulting your local
MPE 70 distributor.
This manual must be read and completely
understood by the responsible specialist
personnel prior to installation and commis-
sioning.
Use of this manual does not relieve opera-
tion and maintenance personnel of the
responsibility of applying normal good
judgment in the operation and care of this
product and its components.
This manual must be available to all person-
nel concerned at the site at all time.
An MPE 70 must always be installed and
used in accordance with existing national
and local sanitary and safety regulations
and laws. It is the responsibility of the safety
officer or the chief operator to assure com-
pliance with all local regulations that are not
taken into account in this manual.
The MPE 70 is a rotating machine that typi-
cally operates at high pressure.
Always wear suitable safety and lifting
equipment when handling the MPE 70.
• Bolt the MPE 70 properly to the frame
before start-up to avoid personal
injury and/or damage to the MPE 70.
• The pipe connections to the MPE 70
must be stress-free mounted, securely
fastened to the MPE 70 and well
supported. Improper installation will
or could result in personal injury
and/or damage to the MPE 70.
• Proper installation and care of
shutdown devices and over-pressure
protection equipment is essential.
• All electrical installation work must be
carried out by authorised personnel in
accordance with EN60204-1 and/or
local regulations.
• Install a lockable circuit breaker to
avoid inadvertent starting. Protect the
motor and other electrical equipment
from overloads with suitable
equipment.
• The electric motors must be supplied
with adequate cooling ventilation.
• Improper installation can cause fatal
injuries.
• The MPE 70 must not operate outside
the application range.
• Make sure that the pressure is
released from the MPE 70 before the
MPE 70 is disconnected from any pipe
connections.
• Before intervening in the
MPE 70/system, the power must be
shut off and the starting device must
be locked. When intervening in the
MPE 70 unit, follow the instructions
for Service/Maintenance, chapter 8.
• A failure not to follow the instructions
can result in personal injury and/or
damage to the MPE 70. It will also
invalidate the warranty.
• The MPE 70 must never run dry. Dry
running produces heat and will cause
damage to internal parts.
• If the MPE 70 does not function
satisfactorily, contact your local MPE
70 distributor.
Use of this manual does not relieve
operation and maintenance personnel
of the responsibility of applying normal
good judgment in the operation and
care of this product.