Safety technology: MCB14x Document No.:
MG34Y104
Rev.: 06 23 October 2012 Page 5 of 25
1.4. Safety regulations
•
The device may only be installed and commissioned by a qualified electrician or suitably trained individual,
both of whom are familiar with these Operating Instructions and the applicable provisions regarding
occupational health and safety and accident prevention.
•
Please observe the various VDE and local provisions, in particular regarding protective measures.
•
If the safety regulations are not observed, then this may lead to death, severe personal injuries or
considerable property damage.
•
Make sure you comply with the various conditions according to EN 60068-2-1, 2-2 as regards
transportation, storage and operations.
•
Any unauthorised refurbishment work shall void any warranty in place. This may cause hazards that lead to
serious injury or even death.
•
Mount the device in a control cabinet that with at least an IP54 enclosure rating. Dust and moisture can
also interfere with the various operations. Mounting in a control cabinet is mandatory.
•
Make sure there is a sufficient de-saturation circuit on all output contacts for capacitive and inductive loads.
•
The device must be installed whilst taking into account the clearances requested according to DIN EN
50274, VDE 0660-514.
•
Any protection covers should not be removed during operation.
•
Replace the device after the first fault has occurred.
•
Dispose of the device correctly once its lifetime has expired.
•
Make sure you keep hold of this product information.
•
If the various safety regulations are not observed, or if they are applied incorrectly, then the company DINA
Elektronik GmbH shall not assume any liability for any ensuing damage to persons or property.
