Danfoss EM-PMI240, Руководство пользователя

Страница: 51 / 59

Electric machine installation checklist
Date:
Table 13. Electric machine and customer information
Customer: Electric machine type (from the rating plate):
Customer reference: Electric machine serial number:
Service reference: Date installed:
N.A = Procedure not applicable PASS = Procedure passed FAIL = Procedure failed
Table 14. Installation checklist
Approval N.A PASS FAIL
General
Electric machine type is correct
☐ ☐ ☐
Electric machine is undamaged
☐ ☐ ☐
Insulation resistance check >150MΩ
☐ ☐ ☐
Environmental conditions as speci ed (see data sheet)
☐ ☐ ☐
Mechanical installation
Supporting structure as required
☐ ☐ ☐
Shaft alignment as speci ed (see chapter Shaft alignment and load).
☐ ☐ ☐
Cooling circuit connected and coolant owing
☐ ☐ ☐
Used coolant:
Power connections
Cable gland assembly as speci ed (cable gland to cables) with correct cable diameter
☐ ☐ ☐
The phase connections order is correct (U, V, W -> L1, L2, L3)
☐ ☐ ☐
Grounding
Electric machine enclosure grounding connected
☐ ☐ ☐
Low voltage cable shield grounding connected
☐ ☐ ☐
Power cable shield connection resistances to ground (electric machine enclosure) measured and valid
☐ ☐ ☐
Low voltage cable shield grounding resistances measured and valid
☐ ☐ ☐
EM-PMI240
13. Storage, installation and maintenance checklists
50 |
©
Danfoss | Produced By: Danfoss Power Solutions | September 2020
| BC355256345493en-000103