Danfoss EM-PMI240, Руководство пользователя

Страница: 26 / 59

Figure 12. Vertical lifting
1. Codipro DSR M 8 UP or equivalent of dimensions and load capacity.
Use swivel type M8 lifting rings with sufficient rated capacity to each loading direction. Refer to
lifting ring manufacturer instructions when attaching lifting rings to machine. It is important that
lifting rings are propely tightened in place
Storage
Do not touch the electrical terminals when the shaft is rotated. The electrical terminals have dangerous voltage during
rotation.
Store the electric machine always indoors with the storage temperature above -20 ºC and the
relative humidity less than 60 %.
The storage should be dry, dust free and vibration free.
Treat the unprotected electric machine surfaces such as the shaft-end and anges against
corrosion. Seal the cable exit holes and cooling bores for storage.
The electric machine must not be subject to any external vibrations during storage to avoid
damage to the bearings.
Use anti-condensation heaters, if tted, or direct winding heating to avoid water condensing in
the electric machine.
Rotate the shaft of the electric machine by hand monthly at least ten revolutions to prevent
grease migration. If necessary, use a tool, for example a spanner. Do not damage the shaft in
any case.
Extended storage
It is recommended to inspect the electric machine in storage at periodic intervals. Use attached
storage checklist.
Rotate the shaft of the electric machine once a month.
Keep the electric machine in its installation position while in storage. For example, vertically
installed electric machines should be stored in vertical position.
EM-PMI240
5. Transportation and storage
| BC355256345493en-000103
©
Danfoss | Produced By: Danfoss Power Solutions | September 2020 | 25