User Guide
|
Danfoss Gas sensor. Type DGS. Modbus or Service Tool display operation
6 | RS8KD102
© Danfoss | DCS (ADAP-KOOL®) | 2018.12
3.1
Function of the keys and LEDs
on the keypad
Exits programming, returns to the previous menu level.
Enters sub menus, and saves parameter settings.
Scrolls up & down within a menu, changes a value.
Change of cursor position.
The status LEDs indicate the operating state.
•
Green
Continuous = Operating voltage
Flashing = Maintenance message
•
Yellow
Continuous = Failure
Slowly flashing = Warming-up
Fast flashing = Special mode
•
Red
= Alarm
The backlight of the display changes from green
to red when an alarm is active.
3.2
Setting / changing of
parameters and set points
Open desired menu window.
Code input field opens automatically, if no code is approved.
Set the desired parameter / set point with the keys.
After input of valid code the cursor jumps onto the first position segment to be changed.
Push the cursor onto the position segment, which has to be changed.
Save the changed value, confirm storage (ENTER).
Cancel the save / close editing / return to a higher menu level (ESCAPE function).