Danfoss CF-RC, Инструкция

Страница: 14 / 20

Danfoss Heating Solutions VIUHM602 © Danfoss 03/2011 14
6.1.5.1 2-pipe
Menu

Setup

Service

Heating/Cooling

2-pipe: Select 2-pipe to configure auto-
matic heating/cooling for a 2-pipe system.
Heating/Cooling
Configuration 2-pipe
Change-over Low 22°C
Change-over High 26°C
Change Back
Select
Change-over Low
or
Change-over High
to set change-over temperatures. Settings
must be between 10 and 50°C with a min. difference of 4°C.
6.1.5.2 3-pipe (4-pipe)
Menu  Setup  Service  Heating/Cooling  3-pipe (4-pipe): Select 3-pipe (4-pipe) to
configure automatic heating/cooling for a 3-pipe (4-pipe) system.
Heating/Cooling
Configuration 3-pipe
Mode Heating
Master room Living room
Neutral zone 2K
Number of outputs 2
Change Back
• Mode: Set the heating/cooling mode to Auto , Heating or Cooling .
• Master room: Select which room should be the Master room. Only rooms with a CF-RD
room thermostat are listed and selectable.
• Neutral zone: Set the Neutral zone parameter to 2K or 4K.
• Number of outputs: Set number of outputs to 0, 2 or 4 (options for 2 and 4 outputs are
only selectable, if all 2/4 outputs are connected to actuators and not already in use).
4 outputs on Master Controller must be configured as outputs for 3- and 4-pipe sys-
tems (if the system contains more Master Controllers, all outputs must be from Master
Controller 1).
Outputs for 3- or 4-pipe systems are:
• Output 1: Warm water supply (used in 3- and 4-pipe systems).
• Output 2: Cooling water supply (used in 3- and 4-pipe systems).
• Output 3:
Warm water return (used in 4-pipe systems).
• Output 4: Cooling water return (used in 4-pipe systems).
Instruction CF-RC Remote Controller