1
Installation Steps
2
Wiring
Installation Guide
WT-DM Installation Instruction
Danfoss Heating Solutions
2
The User Guide can be downloaded from: heating.danfoss.com.
1.
Installation must be done by an authorised electrician.
2. The room thermostat should be installed at approx. 1.5 m
above floor and where the effects of sunlight, draught or
other heat sources (eg. TV's) are avoided. See fig.
1.
3. First of all, carefully remove the cover. See fig.
2.
4. Connect the wire before mounting the back plate to the
wall box using the enclosed screws. Then mount the cover
to the back plate. See fig.
3.
1. Dimensions, see fig.
4.
2. Wiring diagram,see fig.
5.
(S1,S2:floor sensor terminals;A+,B-:
Modbus communication terminals).
3. WT-DM is often used with Danfoss TWA actuator. Depending
on the conditions of power location and actuator type (NC or
GB
Содержание BasicPlus2 WT-DM
