Installing the Cable Clamps
Use the following steps to install the cable clamp brackets, 6 large cable clamps, and 1 small cable clamp. Use the large clamps for
mains and motor cables, and the small clamp for control wiring.
1.
Position the 4 holes in the edge of the extension
bracket over the 4 threaded studs on the drive back-
channel.
2.
Fasten 4 M8 hex nuts (T30), securing the extension
bracket to the studs.
3.
Position the 4 holes in the corners of the cable
bracket over the 4 threaded studs on the front of the
extension bracket.
4.
Fasten 4 M6 hex nuts (T25), securing the cable
bracket to the studs.
5.
Tilt each cable clamp at a 45
º
angle and insert the
hooks through any 2 holes in the bracket. Lower to a
horizontal position.
6.
Insert a cable into each clamp and tighten the cable
adjustment screw to secure the cable.
1
M8 hex nut
6
Clamp adjustment screw
2
Threaded stud
7
Cable clamp, 60 mm
3
Extension bracket
8
Threaded stud
4
Cable clamp, 16 mm
9
M6 hex nut
5
Cable bracket
10
Key hole
Illustration 1.2 Cable Clamp Kit Overview
Installation Instructions
Cable Clamp Kit for E3h/E4h Drives
VLT
®
FC Series FC 102, FC 103, FC 202, and FC 302
MI35U102
Danfoss A/S © 04/2018 All rights reserved.
3