Assembly
5. Raise the bottom cabinet until the hook of the Splay link of the
upper cabinet has hooked into the preset Locking pin.
6. Release the cabinet and insert the second Locking pin (Safety
pin) to secure the Splay link.
To add further cabinets, proceed in the same manner until the
assembly is completed.
6. Splay link of the last cabinet
The Splay link of the last cabinet can be kept in its park position.
Note: In this case, the lowest cabinet can be set to the
following splay angles: 3°, 5° and 7° to 14°.
7. Rig the cabling
Connect the flying cables and link cables according to the number
of amplifier channels and cabinets used.
8. Check the assembly
Before hoisting the array to its operating position recheck the
actual status of the entire assembly.
▪ Check the attachment of the shackles or Rota clamp to the
Flying adapter.
▪ Check the attachment of the Flying adapter to the first cabinet
and ensure all Locking pins are properly inserted and locked.
▪ Check all Front links on both sides of the cabinets and ensure all
Locking pins are properly inserted and locked.
▪ Check the splay angle settings and the Splay links on the rear of
the cabinets and ensure all Locking pins are properly inserted
and locked.
▪ In "Single pick point operation" check the desired total vertical
aiming of the entire array using an inclinometer.
2.4 Hoisting and securing the array (secondary
safety)
When all the mechanical adjustments, system checks and safety
checks have been made, the array can be hoisted up to its
operating position.
When hoisting the array, ensure that the loudspeaker cables do
not get caught anywhere. The cables can be strapped together
with the motor cable to form a loom while the system is hoisted.
The chain hoist motors must raise the system slowly and evenly so
that it does not swing or move from side to side during hoisting.
When the array is in its final operating position the
secondary
safety must be applied.
d&b Z5394 Rigging manual 1.2 en
8
