Dancover ARROW 3m Series, Руководство пользователя

Страница: 8 / 29

7
Manual
Installation manual for Greenhouse ARROW
General view of the frame is given in Picture 1 . Parts should be installed in
such a way that side selves of the profile are facing the surface cover. The
frame is assembled of numbered parts.
Symbols:
-arrow shows the direction of
installation as per schemes in the
manual.
Parts are fastened by putting profiles together and fastening them with
screws and nuts through the holes. When joining parts in “profile-to-
profile” way it does not matter which of the joined parts is above.
When assembling be careful not to damage the parts as they do not
have sufficient endurance before the whole structure is assembled. Use
supports (e.g. chairs) at interim stages of assembly to make sure the frame
is lifted steadily and evenly. To make sure holes coincide when assembling
complicated joints, use a 5 mm thick nail or a cone-shaped hand-punch.
1.
2.
3.
4.
Some parts may have spare
holes which are there due to
uniformity of parts.
introduction
Be careful when assembling the greenhouse! Parts have sharp edges.
Beware of cuts! Perform all works in protective gloves.
When assembling the frame parts should be joined through all holes
as prescribed. A simplified fastening of parts with only one or two
screws is the violation of assembly rules and the ground to relieve the
manufacturer of the warranty responsibility.