Danby DWC518BLS, Руководство пользователя

Страница: 9 / 25

8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
FOR YOUR SAFETY:
While performing installa-
tions described in this
section, gloves, safety
glasses or goggles should
be worn.
Tools you will
Need
Carpenters
Square
Measuring
Tape
Level
Drill & Hole Saw set
Gloves
Safety Glasses
Flashlight
Electrical
Requirements:
The appliance must be
connected to an individual
properly grounded electri-
cal outlet, protected by a
15 or 20 ampere circuit
breaker or time delay fuse.
• It is recommended that you
do not install the wine cooler
into a corner (i.e. directly
beside a wall). This is to allow
the door to have a greater
then 90° opening swing. A
limited door swing will prevent
the shelves from sliding out as
intended, and may lead to
damaging the door gasket.
• The rough cabinet opening
must be on a level floor area
and at least 24” deep by 24”
wide. The opening should
also have a height of at least
34 3/4”.
• The electrical oulet may be
positioned from within either
side of the adjacent cabinetry,
or the rear of the shaded area
(as shown in
Fig E ).
• If the electrical outlet is locat-
ed inside the adjacent cabi-
netry, cut a 1-1/2” diameter
hole to admit the power cord.
If the cabinet wall is metal, the
hole edge must be covered
with a bushing or grommet.
Electrical Access
Fig E
Cabinets
Square
and
Plumb
34 3/4”
From
Underside
of
Countertop
to Floor
24”
6”
24”
Min.
1-1/2” dia. hole
*if electical outlet
is in adjacent
cabinetry
2”