Safety Instructions
Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment.
Properly qualified personnel are persons who are familiar with the transport, assembly, installation,
commissioning and operation of motors, and who have the appropriate qualifications for their jobs. The
qualified personnel must know and observe the following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
Read all available documentation before assembling and commissioning. Incorrect handling of products
in this manual can result in injury and damage to persons and machinery. Strictly adhere to the technical
information regarding installation requirements.
It is vital to ensure that all system components are connected to earth ground. Electrical safety is
provided through a low-resistance earth connection.
The SERVO
STAR
®
product contains static sensitive components that can be damaged by incorrect
handling. Avoid contact with high insulating materials (artificial fabrics, plastic film, etc.). Place the
product on a conductive surface. Ground yourself (discharge any possible static electricity build-up) by
touching an unpainted, metal, grounded surface.
Keep all covers and cabinet doors shut during operation. Otherwise, potential hazards could cause severe
personal injury or damage to the product.
Be aware that during operation, the product has electrically charged components and hot surfaces.
Control and power cables can carry a high voltage, even when the motor is not rotating.
Never disconnect or connect the product while the power source is energized to avoid electric arcing and
hazards to personnel and electrical contacts.
After removing the power source from the equipment, wait at least 10 minutes before touching or
disconnecting sections of the equipment that normally carry electrical charges (e.g., capacitors, contacts,
screwed connections). To be safe, measure the electrical contact points with a meter before touching the
equipment.
Safety symbols indicate a potential for personal injury or equipment damage if the recommended
precautions and safe operating practices are not followed. Read and be familiar with the safety notices in
this manual before attempting installation, operation, or maintenance to avoid serious bodily injury,
damage to the equipment, or operational difficulty. The safety-alert symbols are:
"
Warning
" identifies hazards that could result in personal injury or death.
"
Caution
" identifies hazards that could result in personal injury or equipment
damage.
"
Note
" identifies information required for your understanding or use of the
equipment.
www.szcxi.com | From
：
KOLLMORGEN
