DANA SPICER Torque-Hub S6B, Сборка и разборка, Страница: 10 / 24

5
SECOND STAGE CARRIER SUB-ASSEMBLY
1. Apply grease to the inside of one planet gear (2F) . Line one half of planet gear
(2F) with 18 needle bearings (2C).
2. Place spacer (2D) on top of the needle bearing (2C) .
3. Line the remaining half of planet gear (2F) with 18 needle bearings (2C).
4. Stand carrier housing (2A) on its side. Insert a planet shaft (2E) into one of the
planet shaft holes in carrier housing (2A). The end of the planet shaft that does not
have the dowel pin hole should be inserted first.
5. Place two thrust washers (2B) onto the end of planet shaft (2E) that has been
inserted through the planet shaft hole. Grease or petroleum jelly may be used to hold the
washers together and in place on the planet shaft.
6. Following the thrust washers, place assembled planet gear (2F) onto planet shaft
(2E).
7. Following the planet gear, place two more thrust washers (2B) onto planet shaft
(2E). Grease or petroleum jelly may be used to hold the washers together and in place
on the planet shaft. Now insert planet shaft (2E) into the opposite planet shaft hole in
carrier housing (2A).
8. Using an alignment punch, align the dowel pin holes in carrier housing (2A) and
planet shaft (2E) . Drive dowel pin (2G) into the aligned dowel pin holes in carrier
housing (2A) and planet shaft (2E).
9. Repeat steps 1 to 8 to assemble and install the two remaining planet gears.
10. At this point, the second stage carrier sub-assembly is complete.