
10
Dana inset
TM
II - Preparation and insertion
Read all instructions carefully before using the Dana inset
TM
II infusion set. For information about pump
therapy, possible errors, and potential risks and their causes, consult your pump manufacturer’s instructions
for use before connecting Dana inset
TM
II. When using Dana inset
TM
II‚ follow proper hygiene procedures.
Please see the corresponding illustrations on page 80-82.
[A]
Lid
[B]
Needle guard
[C]
Soft cannula
[D]
Adhesive tape
[E]
Cannula housing
[F]
Connector needle
[G]
Tubing
[H]
Introducer needle
[I]
Insertion device
[J]
Sterile paper
IMPORTANT NOTE!
[K]
Three raised dots – press here when lifting
the lid off (see Figure 6)
[L]
Lined indentations – press here
whenloading Dana inset
TM
II (see Figure 10)
[M]
Round Indentations – press here
simultaneously when releasing
Dana inset
TM
II (see Figure 12)
[N]
Disconnect cover (see Figure B)
CONTENTS
1
Wash your hands before inserting Dana inset
TM
II.
2
Suggested insertion sites. Choose an insertion
site as recommended by your healthcare
provider. Do not use an area right next to your
previous infusion site.
3
Clean the area for insertion with a disinfectant as
directed by your healthcare provider. Be sure the
area is air dry before inserting Dana inset
TM
II.
4
Pull the red tape to remove the seal.
5
Remove the sterile paper.
6
Press the three raised dots on each side of the
lid firmly with one hand and lift up the lid with the
other hand.
CAUTION:
Be careful not to bend or touch the
Dana inset
TM
II introducer needle when
preparing the serter and infusion set.
IMPORTANT NOTE!
If the infusion set is not
securely placed in the insertion device with the
needle pointing straight ahead prior to
insertion, pain or minor injury may occur. To
avoid this, please ensure that the following
steps are taken gently so the infusion set is not
loosened / removed by accident.
7
Unwinding the tubing:
Carefully twist the
beginning of the tubing out of the slot. Now
E N G L I S H