DAN-CHIEF TECHNOLOGY CO., LTD
Page 3 of 4
Manual Version: 1.0
28 Jan 2016
2. According to NCC low power radio wave radiation of regulation:
−
Article 12: The type of equipment which was certified by low power radio
frequency, unlicensed company, firm ,or user shall not alter the frequency,
increase the power, or change the characteristics of the original design and
function.
−
Article 14: The usage of low-power radio-frequency equipment shall not affect
flight safety and interfere with legal communications; If the equipment be founded
by the interference, it should be suspended immediately, and after improve it
until it is without interfering, then it can be continue to be used.
Legal communications in the preceding paragraph refers to radio communication
in accordance with the provisions of the Standards of Telecommunications Act
operation.
This Low-power radio communication equipment must can endure, and it will not
be interfered by the radiation from other legal communications, industrial,
scientific, and medical radio electronic Equipment.
3. Change or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
−
Reorient or relocate the receiving antenna.
−
Increase the separation between the equipment and receiver.
−
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
−
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
