4M Stop Action Camera Manual
PRELIMINARY
39
3.7 Offset and Gain Adjustments
tting
Purpose:
Sets the analog offset. The analog offset should be set so that it is at
least 3 times the rms noise value at the current gain. The analog
offset is factory calibrated and is applicable to exposure mode
sem 2/4
but no calibration is assumed for exposure mode
sem 3/7
.
Syntax:
Syntax Elements:
all taps.
e. Extreme range is
0
-
511
but dynamic
range is dependent of the camera’s current exposure mode
Notes:
r values. A value of 100
does not equal an offset of 100DN.
camera to digitally
the output image.
•
The resulting analog offset value depends on other camera
parameters such as temperature, frame rate, and exposure
mode.
•
The upper input limit of the offset remains the same regardless
of the exposure mode.
t limit of the offset for
sem 3/7
is set at 24 and
s set at 0.
Example:
sao 0 20
exposure mode
sem 3/7
.
Se
Analog Offset
sao t i
t
Tap selection. Allowable value is
0
for
i
Analog offset valu
and gain settings.
•
The offset increases linearly with highe
•
Entering a large value offset will cause the
saturate
•
The lower inpu
for
sem 2/4
i
ed for
Factory Calibrated Analog Gains
The camera has a factory calibrated analog gain setting. Adjustment of analog gain is not
available to the user, however, digital gain is available as set system gain
ssg
.
The calibration is applicable to exposure mode
sem 2/4
but no calibration is assum
DALSA 03-32-10121-09
