50
•
Camera Performance and Features
How to Generate LUT with CamExpert
CamExpert can also be used to create a LUT file. The camera uses a 12-bit in / 12-bit out LUT (even if
the camera is outputting an 8-bit image). CamExpert can be configured to create a 12-bit in / 16-bit out
LUT - the camera will convert it to the required format.
1.
Open CamExpert > version 8.40.
2.
Device
should be a
Xtium2
connected to a
Linea ML / HL
camera.
3.
Under
Board
select
Basic Timing
and set
Pixel Depth
to
12.
4.
Under
Board
select
Image Buffer and ROI
and set
Image Buffer Format
to
Monochrome 16 bits
5.
Leave
Image Buffer and ROI
selected.
6.
In the top menu select
Pre-Processing
|
Lookup Table
and set
Enable.
7.
In the same menu select
Setting…
8.
C
onfigure the output LUT here by scrolling through the different options under
Value.
a.
Some selections have additional parameters to configure (e.g.
Gamma correction
requires a
Correction factor
).
9.
Click on the
Save LUT
button to create a LUT file.
10.
This file can loaded into the camera using the
File Access
features. It is saved with the current
Load / Save Configuration
user set; ensure that a user set and not the factory set is selected,
otherwise the upload will fail.
11.
Deselect the
Lookup Table
|
Enable
feature.
12.
Return CamExpert to
Pixel Depth
= 8, and
Image Buffer
= 8 bits.
Important points:
•
The frame grabber must be configured mono 12 bits in, 16 bits out.
•
In the Parameters explorer a frame grabber feature must be selected, not a camera feature.
•
The Lookup table must be enabled to be created. But should be disabled to use the camera
LUT.
Содержание ML-FM-16K07A
Страница 17: ...Linea ML Multiline Monochrome HDR CMOS Cameras 17 Figure 8 Linea ML FM 16K Camera Mechanical ...
Страница 18: ...18 Linea ML Multiline Monochrome HDR CMOS Cameras Figure 9 Linea ML HM 16K Camera Mechanical ...
Страница 19: ...Linea ML Multiline Monochrome HDR CMOS Cameras 19 Figure 10 ML HM 08K camera mechanical ...
