Dalsa 1M28-SA, Руководство пользователя

Страница: 35 / 54

1M28 and 1M75 User’s Manual PRELIMINARY 35
DALSA 03-32-00525-03
!
REG
Decimal
Value REG
Hexadecimal
Value Read (R) /
Write (W)
or Command
(C) Description
47 30 R/W Choice of a RAM bank for
read/write access
48 30 R/W Byte 0 of a 16x8 RAM-Bank
49 31 R/W Byte 1 of a 16x8 RAM-Bank
50 32 R/W Byte 2 of a 16x8 RAM-Bank
51 33 R/W Byte 3 of a 16x8 RAM-Bank
52 34 R/W Byte 4 of a 16x8 RAM-Bank
53 35 R/W Byte 5 of a 16x8 RAM-Bank
54 36 R/W Byte 6 of a 16x8 RAM-Bank
55 37 R/W Byte 7 of a 16x8 RAM-Bank
56 38 R/W Byte 8 of a 16x8 RAM-Bank
57 39 R/W Byte 9 of a 16x8 RAM-Bank
58 3A R/W Byte 10 of a 16x8 RAM-Bank
59 3B R/W Byte 11 of a 16x8 RAM-Bank
60 3C R/W Byte 12 of a 16x8 RAM-Bank
61 3C R/W Byte 13 of a 16x8 RAM-Bank
62 3E R/W Byte 14 of a 16x8 RAM-Bank
63 3F R/W Byte 15 of a 16x8 RAM-Bank
Register address 00H – 03H (EEPROM control)
The first 4 registers are used to communicate with the EEPROM of the camera. See
Appendix C on page 49 for more information on these registers.
Register address 04H and 05H (Status registers)
The bits of status registers 3 (address 04H) and 4 (address 05H) contain status information
of sensor control registers. Status information of the sensor module can be read from
status register 3. Short-term error messages generated during camera operation (such as
asynchronous communications transmission error) are saved in status register 4. These
error flags can be reset by writing a logical 1 to the corresponding error bit.
Table 10 and Table 11 show the assignment of the registers.
Table 10: Status Register 3 (Register address REGADDR = 4D = 04H)
Register address 4 - STATUS3_REG
Bit
Description
0 = 1
Ł
AUTOLOAD, signals power-up or Reload of data (from EEPROM),
! No write operations to EEPROM allowed !
1 = 1
Ł
PROM_BUSY, ! No write operations to EEPROM allowed !
2 always 0
Ł
sensor module
3 =1
Ł
ERROR_NO_EXSYNC, timeout digital mono flop
4 =1
Ł
ERROR_NO_EXPOSURE, timeout digital mono flop
5 =1
Ł
ERROR_NO_MCLK, timeout digital mono flop
6 Not used = 0