MAXICUT
Page 27
Removal of the cutter drum
The repair is performed on a flat surface with MAXICUT connected to a tractor and
unfolded with both 2 knife drums resting on the ground. It would be a great help to have
a crane or something similar available for both the de- and installation.
Replacing the bearings on the cutter drum
If no crane is available, both axles on the side sections must be removed to
prevent the
drum overturning.
Fig. 13
1.
Both 2 sections must touch the
ground first!
2.
The bolts (A) are loosened on both
ends of the container.
3.
The wheel frame cylinder is activated
and MAXICUT is lifted up on the
wheels.
4.
The bearing can now be pulled out
when the bolt (B) is removed.
Mounting the bearings
1.
The bearing is pushed over the shaft. The two 12
mm bolts are tightly fastened,
together with the large washer.
2.
The wheel frame cylinder is activated and the frame is lowered towards the
bearing. Bolt (A) is mounted and tightened.
There must be no persons within the operating radius when/if the hydraulic system is
activated.
A
B
Содержание MAXICUT 260 Series
