Daktronics Tuff Sport TN-2562, Руководство пользователя

Страница: 36 / 62

30 TNMC Troubleshooting & Maintenance
Figure 19 illustrates some of the primary jacks and indicators of a display driver.
Diagnostic LEDs
The following table explains the functions of the primary diagnostic LEDs on the drivers:
LED Name Color Illumination Summary
DS1 PWR Green Steady on or blinking when the driver has power
DS2 RX Red
Steady on or blinking when the driver is receiving
and off when there is no current loop (CL) signal
Replacing a Driver
1. Access the internal components as described in Section ‎ 6.5 .
2. Disconnect all power and signal connectors from the driver by squeezing together the
locking tabs and pulling the connectors free.
Note: It may be helpful to label the cables to know which cable goes to which
connector when reattaching a driver.
3. Remove the four screws securing the driver to the module. This will be the right-most
module, when viewing the display from the front.
4. Position a new driver over the standoffs on the module and tighten the screws.
5. Reconnect all power/signal connectors.
6. Power up and test the scoreboard/display to see if the problem has been resolved.
Refer to
Figure 20 for an overview of driver (and module) replacement.
Figure 19: Display Driver