Daktronics Tuff Sport TN-2562, Руководство пользователя

Страница: 18 / 62

12 Electrical Installation
Radio Settings
If an All Sport radio receiver is installed, the radio
broadcast settings (“b1”) and the channel settings
(“C1”) will be displayed in the game/set score
digits (
Figure 10 ) during the POST. These values
must match the settings in the control console
(refer to the appropriate control console manual
listed in
Section
‎
1.1 ).
Note: Scoreboards using the RC-100 controller will only display the channel settings.
4.3 Signal Connection Between Scoreboards
Connect a
1
/
4
" phone plug cable between the J32 SIGNAL OUT jack on the first scoreboard
section to the J31 SIGNAL IN jack on next scoreboard section. Repeat this process until all
scoreboard sections are connected. Refer to
Drawing B-233254 in Appendix A .
For the Team Score sections, route the digit cables
from the GUEST section (and clock, if installed)
though the holes in the sides of the cabinets into the
HOME score section, and connect them to the
appropriate jacks on the driver. The GUEST section
TNMC (if installed) uses power/signal interconnect cables.
4.4 Signal Connection with TNMCs
For multi-court scoreboards using team name message centers (TNMCs), signal installation
also requires a wireless base station to receive the signal from the handheld RC-100
controllers, a computer running DakTennis™ software, and a signal converter to send the
wired signal to the display. Refer to
Drawing B-231298 in Appendix A .
1. Plug in the wireless base station (part # 0A-1110-0037) within 12' (3.6 m) of the
DakTennis computer. Ensure the wireless base station is set to
Function “5” .
2. Connect the 9-pin serial cable (part # W-1267) between the RS232 jack of the wireless
base station and an available COM port on the DakTennis computer.
Note: If the DakTennis computer only has only one or no COM port, it will be
necessary to use USB-to-Serial converters (not provided by Daktronics).
3. Connect the other 9-pin serial cable between the DakTennis computer and the J1 jack
of a signal converter (part # 0A-1065-0173).
4. At a minimum, use a paired, 22 AWG shielded cable (part # W-1077) and connect the
cable from the TB1 jack of the signal converter to a
1
/
4
" J-box.
5. Route the cable from the J-box on the control end to a J-box near the display.
6. Install the
1
/
4
" phone plug (part # 0L-40683) to the display end of the cable.
Be sure to connect the cable shielding only in the J-box on this end.
Note: DO NOT connect cable shielding at the J-box near the control console.
7. Route the
1
/
4
" phone plug from the J-box near the display to the scoreboard.
8. Insert the plug into the J31 SIGNAL IN jack on the first scoreboard section, and
connect signal cables between each section as described above.
Figure 10: Radio Settings in Game/Set Digits
Plug(s) Jack(s)
P8 (Guest Score) J8
P1, P2, P3, P4 (Clock) J1, J2, J3, J4
P50 (Guest TNMC)
J50