Daktronics Tuff Sport TN-2560, Руководство по установке

Страница: 14 / 42

Electrical Installation
10
3� Connect the 9-pin to 25-pin serial cable (part # 0A-1374-0106) between the
DakTennis computer and the J6 I/O PORT jack of a radio-equipped All Sport 5000
console.
4� Ensure the All Sport console and the primary scoreboard as well as any auxiliary
single-court scoreboards are set to the same radio Broadcast and Channel numbers.
The console must also be set to Code 5900 .
Radio Communication Considerations
• Ensure the wireless base station is located at least 5' (1.5 m) away from the radio-
equipped All Sport console to minimize interference between the devices.
• The RC-200 wireless base station must be set to a different Channel and/or Group
number than the radio receiver in the scoreboard. Both devices CANNOT be left set
to the default values of “b1C1”.
All Sport CG Setup
Reference Drawings:
System Riser; Tennis; Multi-Court, DakTennis, CG ............................................ DWG-231298
System Riser; Tennis; Multi-Court, DakTennis, Radio, CG .............................. DWG-1077063
System Riser; Tennis; Multi-Court, DakTennis, Radio, CG .............................. DWG-3640119
System Riser; Tennis; Indoor Multi-Court, CG ................................................. DWG-3640403
An All Sport CG allows live game information to be overlaid onto a video signal. This
setup requires an All Sport CG unit and video camera for each court, a signal distribution
amplifier, and associated wiring. Refer to DWG-231298 (RC-100 wired), DWG-1077063
(RC-100 radio), DWG-3640403 (RC-200 wired), or DWG-3640119 (RC-200 radio) for more
information about typical setups.
Connect the display to earth ground. Proper
grounding assures reliable equipment operation
and protects the equipment against damaging
electrical disturbances and lightning. Daktronics
recommends a resistance-to-ground of 10 ohms
or less. The electrical contractor performing the
electrical installation can verify ground resistance.
Daktronics Sales and Service personnel can also
provide this service. The grounding connection on
the power cord’s three-prong plug connects to the
display cabinet.
Note: The customer must properly ground the outlet according to local and national
codes. Failure to ground the outlet voids the warranty.