Daktronics Tuff Sport TN-2560, Руководство по установке

Страница: 13 / 42

Electrical Installation
9
Signal Connection with TNMCs
Reference Drawings:
System Riser; Tennis; Multi-Court, DakTennis, CG ............................................ DWG-231298
System Riser; Tennis; Indoor Multi-Court, CG ................................................. DWG-3640403
For multi-court scoreboards using TNMCs, signal installation also requires a wireless base
station to receive the signal from the handheld RC-100/RC-200 controllers, a computer
running DakTennis™ software, and a signal converter to send the wired signal to the
display. Refer to DWG-231298 (RC-100) or DWG-3640403 (RC-200) in Appendix A .
1� Plug in the wireless base station within 10’ (3 m) of the DakTennis computer.
• For an RC-100, ensure the wireless base station is set to Function “5”.
• For an RC-200, ensure the wireless base station is set to Function “2”.
2� Connect the 9-pin serial cable (part # W-1267) between the RS232 jack of the wireless
base station and an available COM port on the DakTennis computer.
Note: If the DakTennis computer only has only one or no COM port, it will be
necessary to use USB-to-Serial converters (part # A-2221).
3� Connect the other 9-pin serial cable between the DakTennis computer and the J1
jack of a signal converter (part # 0A-1065-0173).
4� At a minimum, use a paired, 22 AWG shielded cable (part # W-1077) and connect
the cable from the TB1 jack of the signal converter to a 1/4” J-box.
5� Route the cable from the J-box on the control end to a J-box near the display.
6� Install the 1/4” phone plug (part # 0L-40683) to the display end of the cable. Connect
cable shielding only in the J-box on this end. DO NOT connect cable shielding at the
J-box near the control console.
7� Route the 1/4” phone plug from the J-box near the display to the scoreboard.
8� Insert the plug into the J31 – SIGNAL IN jack on the first scoreboard section, and
connect signal cables between each section.
Wireless Connection to Scoreboard
Reference Drawings:
System Riser; Tennis; Multi-Court, DakTennis, Radio, CG .............................. DWG-1077063
System Riser; Tennis; Multi-Court, DakTennis, Radio, CG .............................. DWG-3640119
For multi-court scoreboards with TNMCs and a wireless signal to the scoreboard(s),
refer to the instructions below and DWG-1077063 (RC-100) or DWG-3640119 (RC-200) in
Appendix A .
1� Plug in the wireless base station within 10’ (3 m) of the DakTennis computer.
• For an RC-100, ensure the wireless base station is set to Function “5”.
• For an RC-200, ensure the wireless base station is set to Function “2”.
2� Connect the 9-pin serial cable (part # W-1267) between the RS232 jack of the wireless
base station and an available COM port on the DakTennis computer.
Note: If the DakTennis computer only has only one or no COM port, it will be
necessary to use USB-to-Serial converters (part # A-2221).