Daktronics SPORTSOUND SSR-200 GEN II, Руководство по эксплуатации

Страница: 16 / 40

Setup and Operation
12
Wireless Mic System Operation
Basic instructions are described below. For more information about wireless mic system
operation, refer to the Shure QLX-D Wireless System User Guide .
Wireless Receiver
Power IR Window
a
e
b c
d
g
f
h
Power
ON/OFF
Power
ON/OFF
IR Window
Figure 22: Wireless Receiver LCD & Controls
The unit displays the following information ( Figure 22 ):
a� Transmitter Battery Life
b� TV Channel
c� Frequency
d� Group Number
e� Channel Number
f� RF Signal Strength
g� Transmitted Audio Level
h� Gain Level
Single Receiver
1� Ensure all transmitters are powered off� Press the power button to turn on the receiver
if it is not already on.
2� Press menu until “scan” displays on the LCD.
3� Press enter to start frequency scan. When scan is complete, Group and Channel will
display on the LCD.
Network Receivers
1� Ensure all transmitters are powered off� Turn on all receivers and wait one minute to
allow time to connect to the network.
2� Press menu on one receiver until group number flashes.
3� Use the arrow buttons to select a group to scan.
4� Press enter , wait for channel, and then press enter again
5� Press menu until “network scan” displays on the LCD.
6� Press enter twice to deploy channels to other receivers.
Note: Perform a scan on all of the wireless units just minutes before the game! If a scan
is performed too far ahead of time, frequencies set up by the media later on may
interfere with previously configured wireless microphone settings.