Daktronics SPORTSOUND SSR-200 GEN II, Руководство по эксплуатации

Страница: 23 / 40

Maintenance and Troubleshooting
19
Announcer hears nothing
through headphones
Announcer’s interface is not
plugged into appropriate
inputs on the side of the rack.
Plug announcer’s interface into
AUX1 and MIC1 on the side of the
rack.
AUX1 settings are improperly
set on mixer.
Check MIC1 and AUX1 mixer
settings.
Announcer’s interface
HEADPHONE VOLUME is turned
down.
Turn HEADPHONE VOLUME knob to
an appropriate level.
Symptom/Condition Possible Cause Potential Solution
For Wireless
No signal present at mixer
from wireless microphones
The battery is not installed
properly in the transmitter.
Reinstall the battery properly.
The battery is not providing full
power.
Charge or replace battery.
The transmitter is not switched
to the ON position.
Switch the transmitter to the ON
position.
The transmitter and receiver
are set to different channels.
Set to same channel.
Interference on wireless
equipment
Competing RF equipment
within frequency band
1�
Scan for clearest group/channel
on microphone receiver.
2�
Switch wireless receiver and
transmitter to an available clear
channel. Refer to Wireless Mic
System Operation (p�12) .
Low audio signal from
wireless device
Improper gain adjustment on
mixer input
Set proper mixer input gain levels.
Improper gain adjustment on
transmitter output
Set proper transmitter output
gain levels (refer to Shure Wireless
System User Guide ).
Wireless microphone is
cutting out
The battery is not providing full
power.
Charge or replace battery.
Transmitter and Receiver
Antenna are not in line of sight.
Relocate receiver antenna to be in
clear line of sight to field.
Note: If signal goes through tinted
glass, antennas may need to
be relocated outside. Refer
to the High Gain Antenna Kit
Install Guide (DD2497934) .
Ensure referee is placing transmitter
on belt properly. Refer to the
Referee Microphone System Setup
(DD2945863) .