Daktronics FUELIGHT FL-3000 Series, Руководство по установке и эксплуатации

Страница: 33 / 60

FLR3-100/400 Key Fob
29
Edit Cash/Credit Display Hold Time
1� Press and hold the LINE 3 minus (–) and LINE 4 plus (+)
buttons, as shown in Figure 64 , for ~5 seconds until the
hold time is shown on the display.
Note: The default hold time is 3 seconds and is
shown as 30 on the display. Hold times range
from 2 to 9.9 seconds.
2� Use the LINE 1 plus (+) and minus (–) buttons to scroll
through hold times until the desired time is shown.
3� Press and hold the LINE 3 minus (–) and LINE 4 plus (+)
buttons for ~5 seconds to set the selection and exit edit mode.
Control Five or More Fuel Grades or Multiple Pylons
Use the following steps when controlling more than four fuel grades in the same pylon or
when more than one pylon exists on the same site.
•
The same instructions apply to configuration in a sign shop or on-site installation.
• Two or more FLR3-100 key fobs are required.
• Each key fob is limited to controlling a maximum of four grades and only displays a
single pylon.
Important Terms
• Host Display: Display that has the receiver card connected to it
• Fuelight System: Host display and all other displays that are connected to the host
with a line-to-line cable
Option 1: Dedicated (Branch) Circuits
1� Ensure a dedicated branch circuit is installed for each Fuelight system. This allows a
power cycle for each system so the key fob can be synced only to that system.
2� Shut off all power.
3� Power up the first Fuelight system and sync the key fob per Pair Key Fob with Display
(p�14) .
4� After the first Fuelight system and key fob are synced, shut off power to this circuit
after 5 minutes .
5� Power up the second Fuelight system and sync that key fob.
6� Shut down power after 5 minutes�
7�
Repeat this step for additional Fuelight systems.
8� Once all key fobs are synced and marked to designate which Fuelight system they
control, power up all branch circuits.
9� Key fob synchronization is complete.
10� Map the lines of all of the displays in each of the Fuelight systems per Map Line
Numbers (p�26) .
• If there are multiple pylons, repeat the steps above for each pylon.
• Make sure only one pylon is powered on at a time.
Figure 64: Enter/Exit Hold Time
Mode