16
Module Testing and Removal
5.7 Reinstalling a Module (Rear Access)
1. Rotate and carefully guide the module through the module opening.
Note: To ensure proper alignment, verify the word TOP printed on the back of the module is
to the top left of the module.
2. Once the module is through the display face, align the module with the face sheet so the
gravity load pegs fit in the gravity load peg holes. Ensure the lanyard or cables do not pinch
between the module and the display.
3. After the module is in place, use the bottom module lanyard rings or the lanyard to pull the
module firmly against the face sheet.
4. With a
1
/
8
" hex wrench, turn the bottom latch gear approximately a quarter-turn counter-
clock wise to engage the latch.
5. Use the top module lanyard rings or the lanyard to pull the module firmly against the face
sheet.
6. With a
1
/
8
" hex wrench, turn the bottom latch gear approximately a quarter-turn
counterclockwise to engage the latch.
7. Use the top module lanyard rings or the lanyard to pull the module firmly against the face
sheet.
8. With a
1
/
8
" hex wrench, turn the top latch gear approximately a quarter-turn
counterclockwise to engage the latch.
9. Connect the SATA and power cables to the back of the module.
5.8 Hinging and Removing the ISP Enclosure for Module Access
The ISP enclosure hinges out of the way for module access. It can also be lifted off the of the
hinges. To hinge the ISP enclosure out of the way and lift it off the hinges:
1. Locate the quarter-turn latch at the top of the ISP enclosure.
2. Use a flathead screwdriver, turn the quarter-turn latch counterclockwise until the ISP
enclosure disengages.
3. Pull the ISP enclosure from the right to hinge it out of the way.
4. If needed, carefully lift the ISP enclosure off of the hinges on and set aside while ensuring
power and signal cables do not get pinched.
5.9 Hinging and Removing the DMP-8065 for Module Access
The DMP-8065 hinges out of the way for module access. It can also be lifted off the of the hinges.
To hinge the DMP-8065 out of the way and lift it off the hinges:
1. Locate the quarter-turn latch at the top of the DMP-8065.
2. Use a flathead screwdriver, turn the quarter-turn latch counter-clock wise until the DMP-
8065 disengages.
3. Pull the DMP-8065 from the right to hinge it out of the way.
4. If needed, carefully lift the DMP-8065 off of the hinges and set aside while ensuring
power and signal cables do not get pinched.
