Daktronics 4200 Series, Руководство по установке

Страница: 33 / 39

29
First-Time Power Up
Section 10: First-Time Power Up
A laptop is required to communicate with the display. In the ISP enclosure, connect the red Ethernet cable
with the Connect to Laptop tag to an Ethernet power on the laptop.
10.1 First-Time Power Up
1. Loosen the two
3
/
4
turn latches that
secure the Plexiglas ISP enclosure
cover. Refer to
Figure 26.
2. Open the ISP enclosure cover of,
if desired, lift and remove the
Plexiglas ISP enclosure cover off
the hinges.
3. Install the router according to
the ISP schematic. Ensure the
webcam is connected to the
modem, the modem has power,
and the modem is connected to the
network switch.
4. For displays sharing the internet
connection, disconnect the red
cross-over cable from port 5 of the
network switch and run a Cat-5
cable to the router in the secondary
display.
5. Turn on site power at the main
breaker at the structure base.
6. Verify the status lights on the surge suppressor are on.
7. Check the LED indicators on the equipment in the ISP enclosure to ensure they on.
8. Ensure the DMP-8065 LED indicators LEDs are on.
9. Connect a laptop to the red crossover cable in the ISP enclosure.
Note: For back to back displays sharing an internet connection, have the held desk check the
webcam function before connecting the laptop. After the
help desk has verified the webcam function, disconnect
the webcam cable from port 4 of the network switch and
use a Cat-5 cable to connect the laptop to port 4. When
complete, reconnect the webcam cable to port 4.
10. Call Daktronics help desk at 1-877-DAK-HELP to verify
connectivity to the display, perform a diagnostics check,
activate the SmartLink
TM
, and perform several display
setting checks. The help desk technician will ask for the
SmartLink
TM
ICCID number. This number is located on on
the bottom of the SmartLink TM or on the mezzanine card
in the SmartLink
TM
. Refer to
Figure 27.
11. After the help desk verifies the diagnostics is clean and
has performed their tasks, disconnect the laptop from the
cross-over cable and reinstall the Plexiglas ISP enclosure
cover.
Figure 26: ISP Box Door Removal
ICCID
Figure 27: ICCID Number on
Mezzanine Card