Dakota Digital VHX-78C-MC, Руководство пользователя

Страница: 34 / 42

MAN 650314:D 26
INFORMATION MENU
The information menu,
““““
INFO
” is used to display software code information should you
have any troubles; this information can be useful for troubleshooting as well as verifying the
current speedometer calibration value if using the normal speed input (SPD SND).
To view the version of software your instrument system has, press and hold SW1 while
turning the key on. Release the switch. Press and release SW1 to get to the “ INFO ” setup menu.
Press and hold SW1 to enter menu.
VERSION
should be the first option, press and hold SW1 to
view version of software your instrument system has.
The version screen should be displayed as
C VX01.00x
(this line is the controller)
D VH01.00x (this line is the display)
Press and release SW1 to exit back to the “
INFO
” menus.
To view the current pulse per mile (PPM) setting, press and hold the SW1 when “
SPEED CAL
”
is
displayed. The message screen should show “ speed cal xxxx ” where xxxx is the current
PPM setting/calibration value.
Press and release SW1 to exit back to the “
INFO
” setup menu.
When “ Info done ” is displayed, press and hold SW1 until “ done ” is displayed then release the
switch to get back to the main setup menu.
ODOMETER PRESET MENU
The control box will allow you to set the odometer miles to match your current odometer
reading, ONE time within the first 100 miles. Once the odometer has more than 100 miles,
this menu option will no longer be displayed. Make sure you have correctly calibrated
your speedometer so you don’t have to worry about racking up too many extra miles.
Once you have preset the miles, you cannot change it again without sending the control
box back to the factory.
WARNING!!: This only allows setting odometer to the nearest mile. Do not use tenths! For
example an odometer reading of 65432.1 should be set to “
065432
” using this method. If
the tenths digit is used, the odometer will read 10 times too high.
Press and hold SW1 while turning the key on. Release the switch. Press and release SW1 to
get to the “
SET odom
” setup menu. Press and hold SW1 until “
set odo mi
” is displayed to
enter the odometer setup menu, then release SW1.
The current miles will be displayed with the left most digit flashing.
Press and release SW1 to increment the digit. Press and hold the switch to move to the next digit
to the right.
Continue on with a press and release to increment and a press and hold to advance until the right
most digit has been set.
Press and hold SW1 and the speed display will show “
xxxxxx MI save? NO
”, release the
switch.
If the value is incorrect press and hold the switch while “ no ” is displayed to go back and change
the odometer miles or turn the key off to cancel any changes.
If the value is correct press and release the switch to change to “
xxxxxx MI save? YES
”
Press and hold the switch while “ yes ” is displayed to save the current odometer reading and
return to the setup menus.