2
MAN# 650665:A
The MLX-2000 can be used in a variety of tank-mount dashes, including clip-in (1995 and newer), older bolt-in style, and
the Deuce dash. The supplied L-brackets are used for the clip in version while the rubber mounts with studs on both sides
are used for the bolt-in style. The mounting ring is used for Deuce models.
Gauge installation:
(with cable drive speedometer and rubber mounts)
4. Insert the MLX-2000 from the front of dash.
5. Use supplied lock washers and nuts to
secure the gauge to the factory dash.
6. 1995 and older bikes require a cable drive speed sensor; install as shown
with the supplied bracket and screws supplied with the SEN-6011 speed sensor.
Connect the main harness and see page 6 for wiring details.
7. If you’d like to add standard indicators, oil pressure, oil temperature,
air pressure, boost or compass readings to the MLX-2000, connect
the applicable harnesses and route to their appropriate locations;
MBM modules may fit under the seat.
8. Skip to page 5 and complete all electrical aspects of the installation
before reinstalling the dash.
Factory dash panel
Rubber studs
Dakota Digital
MLX-2000
#8 Lock washers
8-32 x ½” nuts
Cable drive speed sensor
with mounting hardware
Foam tape
1. Remove the dash
2. Unbolt and unplug the factory gauge
3. Install the rubber studs and foam tape around the new Dakota Digital
gauge. The tape should apply to the side of the gauge housing and be
against the bottom of the bezel; this fills the opening in the dash.
