8
MAN# 650665:A
Operation, Clock Set, Service Reset
FUNCTION SWITCH
The factory trip reset switch on the side of the dash is used as the main function switch. During normal operation, the
function switch allows access to information including mileage, RPM, and performance data located within two message
locations below the speedometer. The message locations have arrows indicating which message location is currently
selected, or in focus. Tap the function switch to scroll through information available in each location.
If you would like to change focus to another location, press and hold the function switch; you’ll see a status bar labeled
“MOVE FOCUS” filling. Once the status bar is filled, “RELEASE TO MOVE” will be displayed below; if the data in the
selected location can be reset, such as a tripmeter, the bar will be emptying with “HOLD TO CLEAR” displayed above.
Release the switch before the bar empties and the next line of information will be in focus, illustrated by arrows on each
side. Focus alternates top and bottom.
To clear or reset information such as Trip A, Trip B or performance readings, press and hold the function switch until you
see the status bar filling. Continue to hold the switch as the bar empties and then displays “HOLD TO CLEAR”. Hold until
you see “RELEASE” displayed above the status bar. The information will now be reset.
If the function switch is pressed while the key is in the off position, the clock and odometer will be displayed.
SETTING THE CLOCK
The clock uses a 12 hour format and can be set with the key on by holding the function switch while the focus arrow is
next to the clock. If the clock is not shown, tap the function switch until it appears; keep in mind you may need to move to
another message location.
Hold the switch until “RELEASE” is displayed; the hours will begin flashing. Tap switch to change the hours, hold the
switch to move to the minute set and the minutes will begin flashing. Tap the switch to change the minutes; hold the
switch to save and exit the clock set mode.
SERVICE RESET
“SERVICE DUE” may appear at start up, indicating your preselected service time is due.
The screen will go back to the last display shown.
•
To clear the service odometer, after your service was completed, press and release the function switch until the
highlighted “SERVICE DUE” appears in either message location.
•
When “SERVICE DUE” is displayed, hold the function switch until “RELEASE” is displayed.
