3.
PIR settings
Loosen the phillips screw on the bottom of the case and
swivel the top cover up to reveal the PIR board. (The
screw is captured in the case and will not come com-
pletely out.) The jumper settings are as follows:
Detection Range:
High-40 feet
Medium- 25 feet
Low- 12 feet
LED:
ON- led will flash when it detects
OFF- led is always dark
Filter:
ON- set for outdoor use
OFF-set for indoor use
Reset:
15 seconds to reset after activation
120 seconds to reset after reactivation
Dip switches:
1 & 2 should both be OFF
(on the PIR board)
Coding the transmitter:
1. Just above the PIR board is a small clip on the
case. Pull on this clip and the center portion of
the case will swivel down to reveal the radio trans-
mitter and battery slot (figure 2).
Figure 2
