2
Warning:
This device complies with Part 15 of the FCC rules, operation of this device is subject to the follow-
ing conditions: 1. This device may not cause harmful interference. 2. This device must accept any
interference, including interference that may cause undesired operation.
introduction:
The DCR-2500 receiver can be used with any of the Dakota Alert 2500 series transmitters. The
DCR-2500 plugs in to a standard wall outlet and can be placed on a table or mounted on the wall.
When the receiver gets a signal from the transmitter one of 4 different tones (Classical, Westmin-
ster Chime, Ding Dong, Whistle) will sound for a few seconds. There is also a volume control so
you can set the sound to the desired level. The receiver is also equipped with 4 form “C” relays (one
for each zone) and one 12 VDC output terminal that can activate when a signal is received. The
receiver can be user programmed so the 12VDC terminal and relays will activate for 1 second, 10
seconds, 60 seconds or 10 minutes. The tones will sound for several seconds.
operation:
1. Connect the end of the power supply to the receiver (Figure 1-1).
2. Plug the power supply into a wall outlet
3. Locate the off/on switch and move to the “on” position (Figure 1-2).
DCR2500 Manual.indd 2
4/6/2010 8:23:35 AM
