Dake SL96, Инструкция по установке, использованию и обслуживанию

Страница: 16 / 52

USES
The appliance is already arranged both for filte-
ring and for suction performances.
In its filtering version (Fig. 1), the air and fumes
conveyed by the appliance are cleaned both by a
grease filter and by an active coal filter, and put
again into circulation through the side-grids of the
chimney.
In its sucking version (Fig. 2), fumes are direct-
ly conveyed outside, through an evacuation duct
connected with the superior part of the wall or the
ceiling. Both coal filter and air deflector are not
necessary in this case.
INSTALLATION
The manufacturer will not accept any liability
for damages occurred during the appliance
handling/transport and installation opera-
tions.
Carefully read the following installation instruc-
tions , before installing the appliance.
Check that all the components are not damaged.
In case of damages , please contact your retailer
and do not carry out installation.
- Use an air exhaust pipe of the shortest possi-
ble length , with a limited number of elbows, and
made in a certified material .
- Avoid drastic section changes (recommended
constant diameter Ø 150 mm or similar surface).
- The manufacturer will not accept any liability for
air capacity or noise problems , should the above
instructions be ignored. The product will not be
covered by our guarantee for problems resulting
from failure to comply with the aforementioned
instructions.
All of the products have been designed with the
possibility to direct the air out-let towards the ap-
pliance rear side; in case you choose this op-
tion , you will need to remove the no. 10 screws
found in the suctioning unit support (fig. 3 ), pull
the suctioning unit out and rotate it in such a way
as to direct the air out-let nozzle towards the ap-
pliance rear side (fig. 4); then refit the suctioning
unit into place and tighten the screws previously
removed.
With the help of the special drilling template (fig.
5A), please drill the holes for the wall brackets .
The rear, lowest part of the appliance shall be
placed at the following minimum distance from
the cook top:
SLTC93 minimum distance from the cook top:
495mm
SLTC94 - SLTC103 minimum distance from
the cook top: 500mm
LTC95 minimum distance from the cook top:
450mm
SL96 minimum distance from the cook top:
600mm
16