6
Simultaneously
press the
2 bottom keys
for longer than
2 seconds.
Simultaneously
press the
2 bottom keys
for longer than
2 seconds.
The LED lights
up a steady
green = the
keyfob is
ready for the
correct code
to be entered
Enter the old
locking code (1)
by pressing
4 times on the
chosen key
or keys
Enter the new
locking code by
pressing 4 times
on the chosen
key or sequence
of keys
The LED
lights up
a steady
green =
the code
is correct
The LED lights
up a steady
green = the new
code has been
correctly
programmed
about 2 s
0.5 s
0.2 s
The LED
lights up a
steady green
= the keyfob
is ready for
the new
code to be
entered
about 2 s
0.5 s
1 s
Simultaneously
press the
2 bottom keys
for longer than
2 seconds.
The LED lights up
a steady green =
the keyfob is
ready for the
correct code to
be entered
The LED
lights up
a steady
green =
the code
is correct
The LED lights up
a steady green =
the keyfob is locked
or unlocked
about 2 s
0.5 s
0.2 s
1 s
IMPORTANT: if you enter the wrong code or if the 5 s code entry time runs out, the LED will flash red.
red LED
orange LED
green LED
R
O
G
red LED
orange LED
green LED
R
O
G
LED off
LED on
press as
shown
LED off
LED on
press as
shown
G
O
O
O
O
G
O
O
O
O
G
R
G
R
G
O
O
O
O
G
G
R
6. Locking the remote control keyfob via a code
Enter the
locking code by
pressing 4 times
on the chosen
key or sequence
of keys
7. Three-colour LED operation
The viewing of events depends on the devices to be controlled as well as on the type of radio used. Events can only be
viewed on the remote control unit having issued the order and concern the last key pressed (i.e. the last command issued).
(1) Or the factory locking code for a first code change.
Information feedback is displayed when the receiver product acknowledges a command and indicates its status. This
display concerns:
• the TwinBand
®
radio alarm control panel when its system status is modified or queried,
• Optwin
®
wireless products (external receiver or doorphone controller) when these are able to send information about their
status (e.g.: product fitted with a position contact or allocated with a bistable type command like a toggle switch function).
IMPORTANT: the LED does not light up when the key has not been allocated with an Optwin
®
radio link or if it has been
programmed as a “disabled key” (command n° 44) for TwinBand
®
radio.
6.1 Procedure for locking or unlocking the keyfob
This step only concerns the remote control devices SJ604AX and SJ608AX.
Locking the keyfob via a code prevents it from being used. The “code” corresponds to the keyfob being pressed 4 times
(any key or keys).
When the keyfob is locked, a key can be pressed without any commands being transmitted by radio.
The keyfob can only be unlocked using the code or by putting it back into its factory configuration.
The factory configuration of the locking code involves pressing
then
then
and then
.
The procedure is identical in both cases.
6.2 Personalising the locking code
7.1 Information feedback
The keyfob must not be locked.
IMPORTANT: if you
enter the wrong code
or if the 5 s code
entry time runs out,
the LED will flash red.
