5
Keyfob
External receiver and doorphone controller
1.
Switch to radio link creation mode.
2.
Switch to radio link creation or deletion mode.
4.
Select the key to be associated (or deleted)
and validate the procedure
Press briefly on the chosen key.
The LED lights up green for 1.5 s.
Refer to the installation manual of each product.
3.
Select the function.
Refer to the installation manual of each product.
IMPORTANT: choose the top or bottom cursor
position for the SJ608AX.
IMPORTANT: if an error is made, the LED flashes red 3 times. Go through the radio link creation (or deletion) procedure again.
N.B. press briefly on the link creation PB a second time
to exit this mode without waiting until the end of the
5 minute period.
Remove keyfob battery compartment
cover to access Radio link button.
Press briefly on the radio link creation
PB: red LED when the key is pressed
switching to orange when it is released to
indicate the change to radio link creation
mode for a maximum duration of 5 min.
5.1 Creating and deleting the radio link between the remote control keyfob and an Optwin
®
wireless product
IMPORTANT: An Optwin
®
radio link can be created for a key programmed for a TwinBand
®
command n°. If the radio link is
deleted the key returns to its initial command n° setting.
5. Radio link between the remote control keyfob and an Optwin
®
wireless product
This step is for creating (or deleting) a radio link between a keyfob and:
• an external receiver,
• a doorphone controller.
The keyfob can be programmed to recognise up to 16 products with 16 radio links per key.
A function-allocated radio link can be created or deleted following the same procedure, as described below:
This step only concerns the remote control devices SJ604AX and SJ608AX.
5.2 Deleting the radio links of a keyfob key
Example: the P2 key on the keyfob controls two separate lights via 2 external receivers.
Follow the procedure below to delete the 2 radio links with these 2 receivers.
Procedure:
1.
press briefly on the radio link creation pushbutton on the keyfob,
2.
press and hold the keyfob P2 key for longer than 10 seconds.
The keyfob LED lights up green for 1.5 s to indicate that all of the selected key’s radio links have been deleted.