DAITEM SH195AX, Руководство по установке

Страница: 12 / 26

GB
102
Sensitivity level setting
In most cases, level 1 (factory configuration) and compliance with
installation rules ensure that the room is properly protected and that
pets do not trigger the system.
However, depending on the pet and the configuration of the room,
the detector’s level of sensitivity can be modified so that it has pet
detection zones and pet non-detection zones.
Set according to graph below:
IMPORTANT: the smaller the
pet, the higher the sensitivity
level can be.
To
start
the sequence,
press and hold
the button
until the LED
goes out.
Press
the button
1, 2, 3, 4, 6
or 7 times
to select the
parameter.
Press and
hold
the
button until
the LED
goes out
and then
lights up
again.
Press
the button
1 to 4 times
according
to the
chosen
parameter
value.
To
end
the sequence,
press and hold
the button
until the LED
goes out.
1, 2, 3, 4,
6 or 7
1 to 4
roughly
5 s
roughly 10 s roughly 2 s roughly 10 s
LED
steadily
lit =
program-
ming
confirmed
Size of pet
Large
Small
Sensitivity
level
Level 1 Level 2 Level 3 Level 4
4.3 Parameter-setting procedure
Perform the parameter-setting procedure described below: