DaimlerChrysler LH New Yorker 1994, Электронное руководство по обслуживанию

Страница: 38 / 1203

of Installer, Special Tool 6644-1 with end of ram on
arbor press and start to press bushing into lower
control arm.
(3) Press lower control arm pivot bushing into
lower control arm until Installer, Special Tool 6644-1
squarely bottoms against surface of lower control arm
(Fig. 3). When Installer, Special Tool, 6644-1
squarely touches surface of control arm stop
installing bushing. When Installer, Special Tool
6644-1 squarely bottoms on control arm, bushing is
installed to the correct position in control arm.
(4) Install tension strut into tension strut bushing
on the lower control arm assembly. Position tension
strut in lower control as shown in (Fig. 4), with word
FRONT stamped in tension strut positioned away
from control arm. With an open end wrench on flat of
tension strut to stop tension strut from turning.
Torque NEW tension strut to lower control retaining
nut to 150 N
z
m (110 ft. lbs.)
(5) Install lower control arm and tension strut as
an assembly back on the vehicle. See Lower Control
Arm Installation in this section of the service manual
for the required installation procedure.
TENSION STRUT BUSHING
REMOVE
To perform removal and replacement of the lower
control arm tension strut bushing. The control arm
and tension strut assembly must be removed from the
vehicle. The removal and replacement of the lower
control arm tension strut bushing must be performed
using an arbor press.
(1) Remove lower control arm and tension strut as
an assembly from the vehicle. See Lower Control Arm
Removal in this section of the service manual for the
required removal procedure.
(2) Separate the tension strut from the lower con-
trol arm assembly.
(3) Position lower control arm in arbor press with
tension strut bushing inside Receiver, Special Tool
MB-990799 and special tool supporting lower control
arm (Fig. 5). Position Remover, Special Tool, 6644-4
on top of tension strut bushing (Fig. 5). Using the ar-
Fig. 1 Lower Control Arm Pivot Bushing Removal
Fig. 2 Installing Lower Control Arm Pivot Bushing
Fig. 3 Pivot Bushing Installed In Lower Control Arm
Fig. 4 Tension Strut Installed In Lower Control Arm.
SUSPENSION AND DRIVESHAFTS 2 - 19